Front Bumper Fascia Replacement (ZL1)

Fig 1: Front Bumper Fascia (ZL1)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the front bumper outer valance panel. Refer to Front Bumper Outer Valance Panel Replacement (ZL1) Remove the front wheelhouse liners. Refer to Front Wheelhouse Liner Replacement (ZL1) .
1	Front Bumper Fascia Upper Support Push-In Retainer (Qty: 6)
2	Front Fender Support Bracket Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 7 N.m (62 lb in)
3	Front Bumper Fascia Outer Bracket Bolt (Qty: 6) Tighten 7 N.m (62 lb in)
4	Front Bumper Fascia Bolt (Qty: 2) Tighten 3 N.m (27 lb in)
5	Front Bumper Fascia Lower Bolt (Qty: 2) Tighten 7 N.m (62 lb in)
6	Front Bumper Fascia Lower Screw (Qty: 5) Tighten 7 N.m (62 lb in)
7	Front Bumper Fascia Procedure Disconnect the main electrical connector. Disconnect the headlamp washer hose if equiped. Transfer parts as needed.