LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Trax LTZ, FWD >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 1.4L (LUJ LUV) - Repair Instructions >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Camshaft Position Actuator Solenoid Valves
    GM2191796Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    The camshaft position actuator solenoid valves must be kept parallel to the engine front cover during removal and installation. The camshaft position actuator solenoid valves can be damaged if they become wedged or stuck during this process.

    NOTE:

    Lubricate the seal rings with oil in order to make the installation easier.

  1. Carefully install the 2 camshaft position actuator solenoid valves (2) and the 2 seal rings (1) by gently pressing into position.
    2. Fig 2: Camshaft Position Actuator Solenoid Valve Bolts
    GM2191794Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the 4 camshaft position actuator solenoid valve bolts (1) and tighten to 8 N.m (71 lb in).
    3. Fig 3: Camshaft Position Actuator Solenoid Valves Proper Position
    GM2191797Courtesy of GENERAL MOTORS COMPANY
  3. The 2 camshaft position actuator solenoid valves should be installed in the position as shown (1) and (2).
    4. Fig 4: ECM Wiring Harness
    GM2191792Courtesy of GENERAL MOTORS COMPANY
  4. Clip ECM wiring harness (1) to camshaft cover.
  5. Connect the exhaust camshaft position actuator solenoid valve wiring harness plug (2).
  6. Connect the intake camshaft position actuator solenoid valve wiring harness plug (3).
scientia non olet · About LEMON Manuals