LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Trax LS, Standard Trans >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wiring Systems And Power Management - Repair Instructions >> Repair Instructions >> Ignition and Start Switch Replacement (Encore)

Ignition and Start Switch Replacement (Encore)

Fig 1: Ignition And Start Switch
GM2788782Courtesy of GENERAL MOTORS COMPANY
Ignition and Start Switch Replacement (Encore)

Callout Component Name

Preliminary Procedure

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  3. Remove the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement (Encore) .
1 Theft Deterrent Plate Fastener (Qty: 3)
CAUTION:

Refer to Fastener Caution .

NOTE:

Some markets may not be equipped with a theft deterrent plate.

2 Theft Deterrent Plate
NOTE:

Some markets may not be equipped with a theft deterrent plate.

3 Ignition and Start Switch Fastener (Qty: 2)
4 Ignition and Start Switch
Procedure 
Disconnect the ignition and start switch electrical connector.