LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Malibu LS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.0L (LTG) Or 2.5L (LKW) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Valve Stem Oil Seal and Valve Spring Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Valve Guide Seal Remover/Installer
    GM2401716Courtesy of GENERAL MOTORS COMPANY
  1. Using the EN-36017  seal remover (1) install the NEW valve seal. Fully seat the seal onto the valve guide.
    2. Fig 2: View Of Valve Spring, Keepers & Retainer
    GM2401713Courtesy of GENERAL MOTORS COMPANY
  2. Install the valve spring (3) and retainer (2).
  3. Compress the valve spring using the valve spring compressor.
  4. Install the valve spring keepers (1).
  5. Disconnect the air hose and air hose adapter.
    6. Fig 3: Cylinder Head Valve Spring Compressor
    GM1675271Courtesy of GENERAL MOTORS COMPANY
  6. Remove the EN-43649  compressor and EN-43649-10  adaptor set from the cylinder head.
  7. Install the spark plugs. Refer to Spark Plug Replacement .
  8. Install the camshaft. Refer to Intake Camshaft Replacement (LKW) , or Camshaft Position Actuator and Camshaft Replacement - Exhaust (LTG) , Camshaft Position Actuator and Camshaft Replacement - Exhaust (LKW) .
  9. Remove the EN-43653  holding tool.
  10. If equipped with an automatic transmission, install the starter. Refer to Spark Plug Replacement .
scientia non olet · About LEMON Manuals