LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Malibu LS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.0L (LTG) Or 2.5L (LKW) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Engine Oil Level Indicator Switch Replacement >> Removal Procedure

Removal Procedure

  1. Remove the lower oil pan. Refer to Lower Oil Pan Replacement .
  2. Disconnect the oil level sensor electrical connector.
    3. Fig 1: Engine Oil Level Sensor C-clip
    GM2812244Courtesy of GENERAL MOTORS COMPANY
  3. Remove the engine oil level sensor C-clip (1).
    4. Fig 2: Engine Oil Level Sensor Fasteners
    GM2812245Courtesy of GENERAL MOTORS COMPANY
  4. Remove the engine oil level sensor fasteners (1).
    5. Fig 3: O-ring Around Level Sensor
    GM2812246Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Replace the O-ring around the level sensor.

  5. Remove the engine oil level sensor (1) from the oil pan.
scientia non olet · About LEMON Manuals