LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Malibu LS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.0L (LTG) Or 2.5L (LKW) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Automatic Transmission Flex Plate Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Flywheel Attaching Bolts
    GM2726718Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Fasteners have adhesive patch and must be tightened to final torque within 5 minutes.

  1. Install the automatic flex plate (2) and hand start NEW bolts (1).
    2. Fig 2: Starter Motor Bolts
    GM2744964Courtesy of GENERAL MOTORS COMPANY
  2. To prevent crankshaft rotation, install EN-50792  automatic flex plate holding tool (2) and starter motor bolts (1) at the starter motor location and engaging the flex plate.
    3. Fig 3: Tightening Bolts First Pass In Sequence
    GM2744962Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Tighten the bolts evenly using the following procedure:
    1. Tighten the bolts a first pass in sequence to 20 N.m (15 lb ft).
    2. Tighten the bolts a second pass in sequence to 30 N.m (22 lb ft).
    3. Tighten the bolts a final pass in sequence 40 degrees using the EN-45059  meter.
  4. Remove EN-50792  automatic flex plate holding tool.
  5. Install the transmission. Refer to Transmission Replacement .
scientia non olet · About LEMON Manuals