LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Malibu LS >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 2.0L (LTG) Or 2.5L (LKW) - Repair Instructions - Service And Replacement >> Repair Instructions >> Crankshaft Position Sensor Replacement

Crankshaft Position Sensor Replacement

Fig 1: Crankshaft Position Sensor
GM2809897Courtesy of GENERAL MOTORS COMPANY
Crankshaft Position Sensor Replacement

Callout Component Name
Preliminary Procedure 
Remove the starter. Refer to Starter Replacement (LUK) , Starter Replacement (LTG) , Starter Replacement (LKW) .
1 Crankshaft Position Sensor Fastener
CAUTION:

Refer to Fastener Caution .


Tighten 
10 (89 lb in)
2 Crankshaft Position Sensor

Procedure

  1. Disconnect the electrical wiring harness connector from the crankshaft position sensor.
  2. Install a NEW seal if not replacing the sensor.
  3. If installing a new sensor, perform the crankshaft position system variation learn procedure. Refer to Crankshaft Position System Variation Learn .
scientia non olet · About LEMON Manuals