Rear Compartment Floor Panel Trim Replacement (With Blower Cover, HP6)

Fig 1: Rear Compartment Floor Panel Trim & Retainers (With Blower Cover, HP6)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Rear Compartment Side Trim Panel (Push-In) Retainer (Qty: 4) Procedure Pull the rear seat back cushion latch release located on the top of the rear seat back cushion, and fold the rear seat back cushion forward to access two of the (Push-in) retainers. The other two can be accessed through the rear compartment. NOTE: When reinstalling lower interior push-in retainer, lift seat 40-45 degrees above flat to gain sufficient hand room to get retainer seated.
2	Rear Compartment Floor Panel Trim Assembly (with Blower Cover, HP6)

Callout

Component Name

Rear Compartment Side Trim Panel (Push-In) Retainer (Qty: 4)
Procedure
Pull the rear seat back cushion latch release located on the top of the rear seat back cushion, and fold the rear seat back cushion forward to access two of the (Push-in) retainers. The other two can be accessed through the rear compartment.

NOTE:

When reinstalling lower interior push-in retainer, lift seat 40-45 degrees above flat to gain sufficient hand room to get retainer seated.

Rear Compartment Floor Panel Trim Assembly (with Blower Cover, HP6)