Front Bumper Fascia Replacement
Courtesy of GENERAL MOTORS COMPANY Front Bumper Fascia Replacement
| Callout |
Component Name |
|
Preliminary Procedures
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
- Remove the front compartment front sight shield. Refer to Front Compartment Front Sight Shield Replacement
.
|
| 1 |
Front Bumper Fascia Lower Bolt (Qty 2)
|
| 2 |
Front Bumper Fascia Lower Push-In Retainer (Qty: 4) |
| 3 |
Front Bumper Fascia Bolt (Qty: 2) |
| 4 |
Front Bumper Fascia to Fender Outer Bolts (Qty: 2)
NOTE:
These bolts are accessed through the wheelhouse opening
|
| 5 |
Front Bumper Fascia Upper Bolts (Qty: 2) |
| 6 |
Front Bumper Fascia Upper Screws (Qty 6) |
| 7 |
Front Bumper Fascia Procedure
- Turn wheel inboard.
- Remove the four screw from the wheelhouse panel to front fascia.
- Reposition the wheelhouse liner down and away from the fascia bracket.
- Remove the front fascia to fender bolt (3).
- Carefully push a small nylon wedge between the fascia and the front fascia guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the front fascia guide.
- Disconnect any electrical connectors.
- Transfer components as necessary.
|