Removal Procedure
- Remove the oil pan. Refer to Oil Pan Replacement .
- Remove the engine front cover. Refer to Engine Front Cover Replacement .
- Remove the oil pump screen bolt (405) and nuts (404).
- Remove the oil pump screen (407) with O-ring seal (406).
- Remove the O-ring seal from the pump screen.
- Discard the O-ring seal.
- Remove the remaining crankshaft oil deflector nuts.
- Remove the crankshaft oil deflector.
- Remove the oil pump bolts (411).
- Remove the oil pump (413).
- Clean and inspect the oil pump. Refer to Oil Pump Cleaning and Inspection .
NOTE:
Do not allow dirt or debris to enter the oil pump assembly, cap end as necessary.