LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Express 1500 LS, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 4.8L (L20), 5.3L (LMF), Or 6.0L (L96 LC8) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Oil Level Indicator Tube Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Oil Level Indicator, Tube Bolt, Indicator Tube & O-Ring Seal
    GM1658141Courtesy of GENERAL MOTORS COMPANY
  1. Lubricate the O-ring seal (421) with clean engine oil.
  2. Install a NEW O-ring seal onto the oil level indicator tube, if required.
  3. Install the oil level indicator tube (420) between the exhaust manifold and engine block.
  4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Insert the oil level indicator tube into the block.

    The tube must be installed with the collar flush to the block.

  6. Lower the vehicle.
    7. CAUTION:

    Refer to Fastener Caution .

  7. Install the oil level indicator tube bolt (419) and tighten to 25 N.m (18 lb ft).
  8. Install the oil level indicator (418).
  9. Position the coolant recovery reservoir and install the retaining bolt.
  10. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals