LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Express 1500 LS, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 4.8L (L20), 5.3L (LMF), Or 6.0L (L96 LC8) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Left Side >> Removal Procedure

Removal Procedure

    Fig 1: Engine Mount To Engine Mount Bracket Bolts
    GM829685Courtesy of GENERAL MOTORS COMPANY
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (6-Lug Wheel) , Tire and Wheel Removal and Installation (8-Lug Wheel) .
  3. Remove the front propeller shaft, 4WD vehicles only. Refer to Front Propeller Shaft Replacement .
  4. Remove the engine mount to the frame mounting bolts through the wheel well.
    5. CAUTION:

    When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal or crankshaft balancer. Jacking against the oil pan may cause it to crack or break.

    NOTE:

    Raise the engine only enough to permit removal of the engine mount.

  5. Raise and suitably support the engine using adjustable (screw type) jackstands.
    6. Fig 2: Engine Mount To Engine Mounting Bolts
    GM829673Courtesy of GENERAL MOTORS COMPANY
  6. Remove the front engine mount to the engine mounting bolts through the wheel well.
  7. Remove the rear engine mount to the engine mounting bolts from under the vehicle.
  8. Remove the engine mount from the vehicle.
scientia non olet · About LEMON Manuals