LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Express 1500 LS, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 4.8L (L20), 5.3L (LMF), Or 6.0L (L96 LC8) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Drive Belt Replacement - Accessory >> Installation Procedure

Installation Procedure

    Fig 1: Drive Belt Routing
    GM678802Courtesy of GENERAL MOTORS COMPANY
  1. Route the drive belt around all the pulleys except the idler pulley.
  2. Install the breaker bar with hex-head socket to the belt tensioner bolt.
  3. Rotate the belt tensioner clockwise in order to relieve the tension on the tensioner.
  4. Install the drive belt under the idler pulley.
  5. Slowly release the tension on the belt tensioner.
  6. Remove the breaker bar and socket from the belt tensioner bolt.
  7. Inspect the drive belt for proper installation and alignment.
    8. CAUTION:

    Refer to Fastener Caution .

  8. Position the coolant recovery reservoir and install the retaining bolt and tighten to 11 N.m (97 lb in).
  9. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals