LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Express 1500 LS, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 4.8L (L20), 5.3L (LMF), Or 6.0L (L96 LC8) - Repair Instructions - Off Vehicle >> Repair Instructions - Off Vehicle >> Valve Rocker Arm Cover Removal - Right Side

Valve Rocker Arm Cover Removal - Right Side

    Fig 1: View Of Spark Plug Wires, Ignition Coil Bracket Studs & Ignition Coil And Bracket Assembly
    GM1905666Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:

    Do not remove the oil fill tube from the cover, unless service is required. If the oil fill tube has been removed from the cover, install a NEW tube during assembly.

  1. Remove the spark plug wires (724).
  2. Remove the ignition coil bracket studs (720).
  3. Remove the ignition coil and bracket assembly (719).
  4. Fig 2: View Of Bracket, Bolts, Coils & Wire Harness
    GM1402020Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the ignition coil electrical connectors.
  6. Remove the bolts (723), coils (722) and wire harness (721) from the bracket (719), as required.
  7. Fig 3: View Of Cover Bolts With Grommets
    GM1905668Courtesy of GENERAL MOTORS COMPANY
  8. Remove the valve rocker arm cover bolts and cover.
  9. Remove and discard the valve rocker arm cover gasket, valve rocker arm cover grommets and valve rocker arm cover bolts if they are serviced with the grommet.
  10. Fig 4: View Of Valve Rocker Arm Cover Gasket
    GM1272820Courtesy of GENERAL MOTORS COMPANY
  11. Remove the gasket (504) from the cover.
  12. Fig 5: View Of Grommet And Cover
    GM1905670Courtesy of GENERAL MOTORS COMPANY
  13. Remove the grommet (423) from the cover.