Valve Rocker Arm Cover Removal - Left Side
Courtesy of GENERAL MOTORS COMPANY
- Remove the spark plug wires (724).
- Remove the ignition coil bracket studs (720).
- Remove the ignition coil and bracket assembly (719).
Courtesy of GENERAL MOTORS COMPANY
- Disconnect the ignition coil electrical connectors.
- Remove the bolts (723), coils (722) and wire harness (721) from the bracket (719), as required.
Courtesy of GENERAL MOTORS COMPANY
- Remove the valve rocker arm cover bolts and cover.
- If the valve rocker arm cover grommets are cracked or damaged, replace the valve rocker arm cover bolts. The grommet is serviced with the rocker arm cover bolt.
Courtesy of GENERAL MOTORS COMPANY
- Remove and discard the valve rocker arm cover gasket (504) from the cover.