Circuit/System Verification

IMPORTANT:

Before performing this diagnostics, make sure no indicator(s) are illuminated after the IPC performs the displays test. If any indicators are illuminated after the bulb test, perform the indicator diagnostics before this diagnostic.

Ignition ON, headlamp switch OFF, verify the scan tool Headlamp Switch parameter is Inactive.
- If not Inactive, refer to Headlamps Malfunction .
Ignition ON, park lamp switch OFF, verify the scan tool Park Lamp Switch parameter is Inactive.
- If not Inactive, refer to Park, License, and/or Tail Lamps Malfunction .
Ignition ON, doors closed, verify the scan tool Door Ajar Switch parameters are Door Closed.
- If not Door Closed, refer to Courtesy Lamps Malfunction .
Ignition ON, radio ON, adjust the radio balance and fade to the left front speaker.
- If the speaker does not operate properly, refer to Speaker Malfunction .
Ignition ON, perform the Chime Test with the scan tool (only if equipped with a chime module). Verify the chime sounds when commanded from the scan tool.
- If the chime does not sound, replace the chime module.
Verify that the Key In Ignition Status parameter is Key In when the key is in the ignition and Key Out when the key is out of the ignition.