LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 3.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Valve Stem Oil Seal and Valve Spring Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Valve Stem Oil Seal Removal/Installation
    GM1338340Courtesy of GENERAL MOTORS COMPANY
  1. Use the EN 46116  Valve Stem Seal Remover/Installer (1) in order to install the valve stem seals (2).
    2. Fig 2: View Of Valve Spring
    GM902899Courtesy of GENERAL MOTORS COMPANY
  2. Install the valve spring.
  3. Install the valve spring retainer.
    4. Fig 3: View Of Installed Valve Spring Compressor Tool
    GM1338337Courtesy of GENERAL MOTORS COMPANY
  4. Install the EN 46110  On-Vehicle Valve Spring Compressor above the applicable valve spring as shown.

    Tighten the EN 46110  On-Vehicle Valve Spring Compressor nut (2).

    5. Fig 4: View Of Valve Spring Keepers
    GM902903Courtesy of GENERAL MOTORS COMPANY
  5. Install the valve spring keepers.
  6. Remove the EN 46110  On-Vehicle Valve Spring Compressor.
  7. Disconnect the J 39313  Spark Plug Port Adapter from the compressed air source.
  8. Remove the J 39313  Spark Plug Port Adapter.
  9. Install the spark plugs. Refer to Spark Plug Replacement .
  10. Install the rocker arms and camshafts. Refer to Valve Rocker Arm Replacement - Right Side , and Camshaft Replacement - Right Side .
  11. Remove the EN 46106  Flywheel Holding Tool.
  12. Install the starter motor. Refer to Starter Replacement .
scientia non olet · About LEMON Manuals