LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 3.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Oil Level Indicator Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Intake Manifold Cover & Cap
    GM2667623Courtesy of GENERAL MOTORS COMPANY
  1. Remove the intake manifold cover (2). Refer to Intake Manifold Cover Replacement - Front .
    2. Fig 2: Oil Level Indicator, Tube & Cylinder Head Retaining Bolt
    GM2667581Courtesy of GENERAL MOTORS COMPANY
  2. Remove the oil level indicator (1) from the oil level indicator tube (3).
  3. Remove the oil level indicator tube to cylinder head retaining bolt (3).
    4. NOTE:

    Apply suitable upward pressure to remove the oil level indicator tube from the engine.

  4. Remove the oil level indicator tube (2) from the engine.
    5. Fig 3: Identifying Oil Level Indicator Tube & O-Ring
    GM1958778Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The oil level indicator tube seal is a single use item.

  5. Remove the O-ring (1) from the oil level indicator tube (2) and discard.
scientia non olet · About LEMON Manuals