Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the engine cover. Refer to Intake Manifold Cover Replacement - Rear .
- Use a grade 10.9, M10 X 1.5 X 35 bolt, GM P/N 11519182 or equivalent, in order to install an engine lift bracket (OTC #7100, J 36857 or equivalent) to the front of the left cylinder head in the location shown.
- Support the hood and remove the hood support strut.
- Reposition the passenger side wire harness (1) to provide clearance for support fixture leg.
- Assemble a J28467-501 support leg (1) to each end of the J28467-518 main bar (2).
- Position the main bar (1) with the support legs over each shock tower. Ensure the rear support legs are located over the reinforced section of the shock tower.
- Install the J28467-7A lift hook through the J28467-6A lift hook bracket.
- Install the 1/2 inch lift hook washer and the J28467-34 handle onto the J28467-7A lift hook.
- Install the J28467-6A assembled lift hook bracket (1) over the J28467-16 main bar (2).
- Adjust the J28467-6A assembled lift hook bracket (1) in order to align the hook with the J41798 engine bracket.
- Repeat steps 8-11 for the right lift hook.
- Hand-tighten the lift hook wing nuts securely to remove all slack from the engine support fixture assembly.
- The engine is now supported in the vehicle to perform repairs that require front frame removal.