LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 3.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Mounting Bracket Retaining Nut
    GM2667524Courtesy of GENERAL MOTORS COMPANY
  1. Remove the right hand engine mount to engine mounting bracket retaining nut (1).
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 2: Lower Engine Mount Nuts
    GM2667590Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Removal of both lower engine mount nuts (1) will prevent stretching of the mount that isn't being replaced when the engine is lifted

  3. Remove and discard the engine mount to front frame retaining nuts (1).
  4. Position a screw jack and a block of wood under the engine oil pan.
  5. Using the screw jack, carefully raise the engine until the engine is lifted high enough to remove the right hand engine mount.
    6. Fig 3: Right Hand Engine Mount
    GM2667527Courtesy of GENERAL MOTORS COMPANY
  6. Remove the right hand engine mount (1) from the vehicle.
scientia non olet · About LEMON Manuals