LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 3.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Cylinder Head Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the camshaft cover. Refer to Camshaft Cover Replacement - Right Side .
  2. Remove the fuel feed pipe. Refer to Fuel Feed Pipe Replacement .
  3. Remove the fuel feed intermediate pipe. Refer to Fuel Feed Intermediate Pipe Replacement .
  4. Remove the right bank secondary timing chain. Refer to Secondary Camshaft Intermediate Drive Chain Replacement - Right Side .
  5. Remove the catalytic converter. Refer to Catalytic Converter Replacement - Right Side (LFX) .
  6. Remove the heater inlet and outlet hoses. Refer to Heater Inlet Hose Replacement (LFX) , and Heater Outlet Hose Replacement (LFX) .
  7. Remove the two ground wires attached to the front and rear of the cylinder head.
    8. Fig 1: View Of Right Cylinder Head & Bolts
    GM2202033Courtesy of GENERAL MOTORS COMPANY
  8. Remove the right cylinder head bolts (1).
  9. Remove the right cylinder head (2).
    10. Fig 2: View Of Right Cylinder Head Gasket
    GM2202034Courtesy of GENERAL MOTORS COMPANY
  10. Remove and discard the cylinder head gasket (1).
  11. Clean and inspect the cylinder head and the engine block sealing surfaces. Refer to Cylinder Head Cleaning and Inspection , and Engine Block Cleaning and Inspection .
  12. Disassemble the cylinder head if needed . Refer to Cylinder Head Disassemble (LFX) .
scientia non olet · About LEMON Manuals