LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 3.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Cylinder Head Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the camshaft cover. Refer to Camshaft Cover Replacement - Left Side .
  2. Remove the left bank secondary timing chain. Refer to Secondary Camshaft Intermediate Drive Chain Replacement - Left Side .
  3. Remove the fuel pump. Refer to Fuel Pump Replacement .
  4. Remove the oil filter adaptor. Refer to Oil Filter Adapter Replacement .
  5. Remove the catalytic converter. Refer to Catalytic Converter Replacement - Left Side (LFX) .
  6. Remove the oil level indicator tube. Refer to Oil Level Indicator Tube Replacement .
  7. Remove the ground wire bolt and wire from the cylinder head.
    8. Fig 1: View Of Left Cylinder Head & Bolts
    GM2202035Courtesy of GENERAL MOTORS COMPANY
  8. Remove the 2 front M8 left cylinder head bolts (1).
  9. Remove the left cylinder head bolts (2).
  10. Remove the left cylinder head (3).
    11. Fig 2: View Of Left Cylinder Head Gasket
    GM2202036Courtesy of GENERAL MOTORS COMPANY
  11. Remove and discard the left cylinder head gasket (1).
  12. Clean and inspect the cylinder head and the engine block sealing surfaces. Refer to Cylinder Head Cleaning and Inspection , and Engine Block Cleaning and Inspection .
  13. Disassemble the cylinder head if needed. Refer to Cylinder Head Disassemble .
scientia non olet · About LEMON Manuals