LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Knock Sensor Replacement - Bank 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Knock Sensor (KS) Electrical Connector & Retaining Bolt
    GM1949898Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the knock sensor (2) to the engine block and tighten the retaining bolt (1) to 23 N.m (17 lb ft).
  2. Install the knock sensor electrical (3) connector to the KS.
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals