LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Ignition Coil Replacement - Bank 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
WARNING:

Refer to Safety Glasses and Compressed Air Warning .

  1. Ignition OFF.
    2. WARNING:

    Refer to Battery Disconnect Warning .

  2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove the intake manifold sight shield.
    4. Fig 1: Identifying Ignition Coil To Camshaft Cover Retaining Bolts
    GM1949893Courtesy of GENERAL MOTORS COMPANY
  4. Remove the ignition coil harness connectors from the ignition coils.
  5. Remove the ignition coil to camshaft cover retaining bolts (1).
  6. Remove the ignition coils (2) from the vehicle.
scientia non olet · About LEMON Manuals