LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Purge Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Evaporative Emission (EVAP) Hose
    GM2065618Courtesy of GENERAL MOTORS COMPANY
  1. Position the EVAP hose (2) to the fuel tank.
  2. Attach the EVAP hose (2) to the EVAP hose to fuel tank retaining clips (1).
  3. Install the fuel tank. Refer to Fuel Tank Replacement .
  4. Lower the vehicle to the ground.
scientia non olet · About LEMON Manuals