LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying CMP Sensor To Engine Front Cover Retaining Bolt
    GM1949774Courtesy of GENERAL MOTORS COMPANY
  1. Install the CMP sensor (1) to the engine.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the CMP sensor (1) to engine front cover retaining bolt (2) and tighten to 10 N.m (89 lb in).
    3. Fig 2: Identifying CMP Sensor & Electrical Connector
    GM1949771Courtesy of GENERAL MOTORS COMPANY
  3. Install the CMP sensor electrical connector (1) to the CMP sensor (2).
  4. Install the power steering fluid reservoir. Refer to Power Steering Fluid Reservoir Replacement .
  5. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement - Front .
scientia non olet · About LEMON Manuals