LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition OFF.
  2. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement - Front .
  3. Reposition the vacuum brake booster hose.
    4. Fig 1: Identifying CMP Sensor & Electrical Connector
    GM1949763Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    Refer to Safety Glasses Warning .

  4. Use compressed air to remove debris from the CMP sensor and surrounding cavities.
  5. Remove the camshaft position (CMP) sensor electrical connector (1) from the CMP sensor (2).
    6. Fig 2: Identifying CMP Sensor To Engine Front Cover Retaining Bolt
    GM1949765Courtesy of GENERAL MOTORS COMPANY
  6. Remove the CMP sensor to engine front cover retaining bolt (1).
  7. Remove the CMP sensor (2) from the engine.
scientia non olet · About LEMON Manuals