LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition OFF.
    2. NOTE:

    Do not disconnect the power steering fluid lines/hoses from the reservoir.

  2. Remove the power steering fluid reservoir bolts and reposition the power steering fluid reservoir in order to provide access. Refer to Power Steering Fluid Reservoir Replacement .
    3. Fig 1: Identifying CMP Actuator Valve & Electrical Connector
    GM1949761Courtesy of GENERAL MOTORS COMPANY
  3. Remove the camshaft position (CMP) actuator valve electrical connector (1) from the CMP actuator (2).
    4. Fig 2: Identifying CMP Actuator Solenoid Valve To Engine Front Cover Retaining Bolt
    GM1949762Courtesy of GENERAL MOTORS COMPANY
  4. Remove the CMP actuator solenoid valve to engine front cover retaining bolt (1).
  5. Remove the CMP actuator valve (2) from the engine front cover.
  6. Inspect the CMP actuator valve seal for damage and replace as necessary.
scientia non olet · About LEMON Manuals