LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
WARNING:

Refer to Safety Glasses Warning .

  1. Turn the ignition OFF.
  2. Remove the power brake booster auxiliary pump. Refer to Power Brake Booster Auxiliary Pump Replacement .
    3. Fig 1: Identifying CMP Actuator Valve & Electrical Connector
    GM1949750Courtesy of GENERAL MOTORS COMPANY
  3. Remove the camshaft position (CMP) actuator valve electrical connector (1) from the CMP (2).
    4. Fig 2: Identifying CMP Actuator Solenoid Valve To Engine Front Cover Retaining Bolt
    GM1949753Courtesy of GENERAL MOTORS COMPANY
  4. Remove the CMP actuator solenoid valve to engine front cover retaining bolt (1).
  5. Remove the CMP actuator valve (2).
  6. Inspect the CMP actuator valve seal and replace as necessary.
scientia non olet · About LEMON Manuals