LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.6L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Oil Pan Assemble (RWD)

Oil Pan Assemble (RWD)

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Oil Pan Drain Plug
    GM2736511Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the oil pan drain plug (1) and tighten the oil pan drain plug to 25 N.m (18 lb ft).
    2. Fig 2: Engine Oil Level Switch & Components
    GM2736508Courtesy of GENERAL MOTORS COMPANY
  2. Install the NEW engine oil level switch seal (3).
  3. Install the engine oil level switch (2).
  4. Install the engine oil level switch bolts (1) and tighten to 10 N.m (89 lb in).
  5. Install NEW engine oil level switch clip (4).
    6. Fig 3: Oil Suction Pipe Seal
    GM2736510Courtesy of GENERAL MOTORS COMPANY
  6. Install the NEW oil suction pipe seal (1).
    7. Fig 4: Oil Suction Pipe & Bolts
    GM2736509Courtesy of GENERAL MOTORS COMPANY
  7. Install the oil suction pipe (2).
  8. Install the oil suction pipe bolts (1) and tighten to 10 N.m (89 lb in).
    9. Fig 5: Engine Oil Pan Scraper & Bolts
    GM2736506Courtesy of GENERAL MOTORS COMPANY
  9. Install the oil pan scraper (1).
  10. Install the oil pan scraper bolts (2) and tighten to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals