LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.6L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Intake Manifold Assemble

Intake Manifold Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Plastic Compression Limiters
    GM2612730Courtesy of GENERAL MOTORS COMPANY
  1. Install the NEW plastic compression limiters (1).
    2. Fig 2: Lower Intake Manifold, Bolts & Gaskets
    GM2612728Courtesy of GENERAL MOTORS COMPANY
  2. Install the NEW lower intake manifold gaskets (3).
  3. Install the lower intake manifold (2) and bolts (1).
    4. CAUTION:

    Refer to Fastener Caution .

  4. Tighten the lower intake manifold bolts (1) to 7 N.m (62 lb in).
    5. Fig 3: MAP Sensor & Retaining Bolt
    GM2219477Courtesy of GENERAL MOTORS COMPANY
  5. Inspect the manifold absolute pressure (MAP) sensor O-ring seal for damage. If the seal is damaged replace the MAP sensor.
  6. Install the MAP sensor (2).
  7. Install the MAP sensor bolt (1) and tighten to 4 N.m (35 lb in).
    8. Fig 4: Identifying EVAP Solenoid
    GM2219476Courtesy of GENERAL MOTORS COMPANY
  8. Inspect the evaporative (EVAP) solenoid O-ring seal for damage. If the seal is damaged replace the EVAP solenoid.
  9. Install the EVAP solenoid (1).
  10. Tighten the EVAP solenoid bolt to 10 N.m (89 lb in).
    11. Fig 5: Identifying Throttle Body Components
    GM2219474Courtesy of GENERAL MOTORS COMPANY
  11. Install the NEW throttle body seal (3).
  12. Install the throttle body (2).
  13. Install the throttle body bolts (1) and tighten to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals