LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.6L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Crankshaft and Bearing Removal >> Crankshaft Removal

Crankshaft Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Crankshaft Main Bearing Cap Side Bolts
    GM902789Courtesy of GENERAL MOTORS COMPANY
  1. Remove the crankshaft bearing cap side bolts.
  2. Remove the crankshaft bearing cap outer bolts.
  3. Remove the crankshaft bearing cap inner bolts.
    4. Fig 2: View Of Crankshaft Main Bearing Caps
    GM1905889Courtesy of GENERAL MOTORS COMPANY
  4. Remove the crankshaft bearing caps using the GE 6125-1B  adapter (1) and EN 49102  remover (2) .
    5. Fig 3: View Of Crankshaft
    GM1866875Courtesy of GENERAL MOTORS COMPANY
  5. Using two hands, lift the crankshaft straight up from the engine block.
  6. Place the crankshaft in a secure place.
    7. Fig 4: Locating Crankshaft Sprocket Drive Pin
    GM1864436Courtesy of GENERAL MOTORS COMPANY
  7. Remove the crankshaft key from the nose of the crankshaft, if damaged.
scientia non olet · About LEMON Manuals