LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.6L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Crankshaft and Bearing Installation >> Crankshaft Installation Procedure

Crankshaft Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Crankshaft Sprocket Drive Pin
    GM1864436Courtesy of GENERAL MOTORS COMPANY
  1. If removed, install the crankshaft key. Lightly tap the key in place with a small soft face, bronze/plastic, hammer until it bottoms in the keyway.
    2. Fig 2: View Of Crankshaft
    GM902743Courtesy of GENERAL MOTORS COMPANY
  2. Gently lower the crankshaft into position in the cylinder block.
scientia non olet · About LEMON Manuals