LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.6L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Crankshaft Rear Oil Seal and Housing Removal

Crankshaft Rear Oil Seal and Housing Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Crankshaft Rear Oil Seal Housing Bolts
    GM1306175Courtesy of GENERAL MOTORS COMPANY
  1. Remove the crankshaft rear oil seal housing bolts.
    2. Fig 2: Identifying Pry Points On Edge Of The Crankshaft Rear Oil Seal Housing
    GM1492611Courtesy of GENERAL MOTORS COMPANY
  2. Use the pry points located at the edge of the crankshaft rear oil seal housing to separate the RTV sealant.
    3. Fig 3: View Of Crankshaft Rear Oil Seal Housing
    GM1306173Courtesy of GENERAL MOTORS COMPANY
  3. Remove and discard the crankshaft rear oil seal housing.
scientia non olet · About LEMON Manuals