LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.6L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Camshaft Position Actuator Removal - Left Side Intake

Camshaft Position Actuator Removal - Left Side Intake

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Camshaft Position Actuator Bolt
    GM1852296Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Torque Reaction Against Timing Drive Chain Caution .

  1. Use an open wrench on the hex cast into the camshaft in order to prevent engine rotation when loosening the camshaft position actuator bolt.
  2. Remove the left intake camshaft position actuator bolt (1).
  3. Remove the left intake camshaft position actuator (2).
  4. Remove the camshaft thrust washer if applicable (3).
scientia non olet · About LEMON Manuals