LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.6L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Camshaft Cover Assemble >> Left Camshaft Cover

Left Camshaft Cover

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Left Spark Plug Shield Tube Seals And Special Tools
    GM1992540Courtesy of GENERAL MOTORS COMPANY
  1. Install the NEW left spark plug shield tube seals using the J 5590  driver (1) and J 24254-A  installer (2) .
    2. Fig 2: View of Left Camshaft Cover Gasket Assembly
    GM1992532Courtesy of GENERAL MOTORS COMPANY
  2. Install the NEW left camshaft cover gasket.
    3. Fig 3: View of Oil Filter Cap Assembly
    GM1992531Courtesy of GENERAL MOTORS COMPANY
  3. Install the oil fill cap.
    4. Fig 4: View of Fuel Injector Sight Shield Cover Ballstud
    GM1992528Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  4. Install the fuel injector sight shield cover ballstud and tighten to 10 N.m (89 lb in).
    5. Fig 5: View of Left Camshaft Cover Bolt Grommets
    GM1992526Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The camshaft cover bolt grommet must be installed into the camshaft cover bolt hole before installing the camshaft cover bolt.

  5. Install the NEW left camshaft cover bolt grommets.
scientia non olet · About LEMON Manuals