Front Bumper Fascia Replacement (Base, RS, SS)
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the front wheelhouse liners. Refer to Front Wheelhouse Liner Replacement (Without ZL1, Z28) . |
|
| 1 | Front Bumper Fascia Upper Support Push-In Retainer (Qty:6) |
| 2 | Front Fender Support Bracket Screw (Qty:2)
CAUTION:
Refer to Fastener Caution . Tighten 7 N.m (62 lb in) |
| 3 | Front Bumper Fascia Outer Bracket Nut (Qty:6) Tighten 7 N.m (62 lb in) |
| 4 | Front Bumper Fascia Bolt (Qty:2) Tighten 3 N.m (27 lb in) |
| 5 | Front Bumper Fascia Lower Bolt (Qty:2) Tighten 7 N.m (62 lb in) |
| 6 | Front Bumper Fascia Lower Screw (Qty:2) Tighten 7 N.m (62 lb in) |
| 7 | Front Bumper Fascia Lower Retainer (Qty:6) |
| 8 | Front Bumper Fascia Procedure Disconnect the main electrical connector. |