LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro LS, Automatic Trans >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Diagnostic Information and Procedures >> Volt Gauge Malfunction >> Circuit/System Verification

Circuit/System Verification

  1. Ignition ON, perform the Auxiliary Gauge Sweep test with the scan tool, verify all auxiliary gauges sweep from the low to high positions.
    • If one, two, or three of the auxiliary gauges sweep properly 

      Replace the P26 Auxiliary Gauge Module.

    • If all auxiliary gauges sweep properly 
  2. Verify that DTC B1420 is not set.
    • If the DTC B1420 is not set 
  3. Replace the P26 Auxiliary Gauge Module.
scientia non olet · About LEMON Manuals