Circuit/System Verification
- Ignition ON.
- Verify the scan tool Fuel Level Sensor parameters are between 0.5-3.5 V and vary with fuel level.
- If not between 0.5-3.5 V or does not vary with fuel level
Refer to Circuit/System Testing
- If between 0.5-3.5 V and varies with fuel level
- If not between 0.5-3.5 V or does not vary with fuel level
- Verify that all fuel level gauge sweeps when performing the scan tool Instrument Cluster Gauge Sweep test.
- If the fuel level gauge does not sweep
Replace the P16 instrument cluster
- If the fuel level gauge sweeps
- If the fuel level gauge does not sweep
- All OK.