Shock Absorber Replacement

Fig 1: Shock Absorber Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation . Remove the rear wheel house panel liner. Refer to Rear Wheelhouse Liner Replacement .
1	Rear Shock Absorber Bolt. WARNING: Refer to Torque-to-Yield Fastener Warning . CAUTION: Refer to Fastener Caution . Procedure Support the rear axle with a suitable jack stand. Remove and DISCARD the bolt. DO NOT re-use, replace with NEW only. Support the front end of the vehicle and raise the rear axle to the proper D Height. Refer to Trim Height Inspection . Tighten First Pass: 150 N.m (111 lb ft) Final Pass: additional 65 degrees.
2	Rear Shock Absorber Bolt (Qty:2) Tighten 100 N.m (74 lb ft)
3	Rear Shock Absorber
4	Rear Shock Absorber Nut Tighten 20 N.m (15 lb ft)
5	Rear Shock Absorber Upper Mount
6	Rear Shock Absorber Upper Bumper