Intermediate Steering Shaft Replacement (NJ1)

Fig 1: Intermediate Steering Shaft & Upper Bolt

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the steering column and the intermediate steering shaft as an assembly. Refer to Steering Column Replacement (Mexico, N40) , Steering Column Replacement (Canada, NJ1) or Steering Column Replacement (United States, NJ1) .
1	Intermediate Steering Shaft Upper Bolt CAUTION: Refer to Fastener Caution . Tighten 49 N.m (36 lb ft)
2	Intermediate Steering Shaft Procedure Place match marks on the intermediate steering shaft and the steering column shaft. If replacing the intermediate steering shaft or the steering column, copy the match marks from the old parts to the new parts. Align the match marks when installing the intermediate steering shaft to the steering column shaft. Set up the power steering control module. Refer to Power Steering Control Module Programming and Setup . Center the steering angle sensor. Refer to Steering Angle Sensor Centering .

Callout

Component Name

Intermediate Steering Shaft Upper Bolt

CAUTION:

Tighten
49 N.m (36 lb ft)

Intermediate Steering Shaft

Procedure

Place match marks on the intermediate steering shaft and the steering column shaft.
If replacing the intermediate steering shaft or the steering column, copy the match marks from the old parts to the new parts.
Align the match marks when installing the intermediate steering shaft to the steering column shaft.
Set up the power steering control module. Refer to Power Steering Control Module Programming and Setup .
Center the steering angle sensor. Refer to Steering Angle Sensor Centering .