Driver Or Passenger Seat Cushion Outer Finish Panel Replacement (Power)

Fig 1: Driver Or Passenger Seat Cushion Outer Finish Panel (Power)

Courtesy of GENERAL MOTORS COMPANY

Driver or Passenger Seat Cushion Outer Finish Panel Replacement (Power)

Callout	Component Name
Preliminary Procedures Remove the driver or passenger seat recliner handle. Refer to Front Seat Back Recliner Handle Replacement Remove the front seat recliner and adjuster knobs.
1	Driver or Passenger Seat Cushion Outer Finish Panel Front Fastener CAUTION: Refer to Fastener Caution .
2	Driver or Passenger Seat Cushion Outer Finish Panel Rear Fastener
3	Driver or Passenger Seat Cushion Outer Finish Panel Procedure Make sure the seat is in the full up position. Gently pull outboard on the front half of the finish cover to disengage the panel rib from the seat frame. Firmly grasp the upper area of the finish cover that folds over the seat cushion frame, this area needs to be flexed outward while sliding the finish cover upward. If replacing the cover, transfer components as necessary.