LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Trax LS, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim And Interior Paneling >> Repair Instructions >> Windshield Garnish Molding Replacement (Chevrolet)

Windshield Garnish Molding Replacement (Chevrolet)

Fig 1: Windshield Garnish Molding Assembly
GM2877813Courtesy of GENERAL MOTORS COMPANY
Windshield Garnish Molding Replacement (Chevrolet)

Callout Component Name
1 Windshield Garnish Molding Assembly

Procedure

  1. Tabs must be installed prior to retainers.
  2. Tabs to be fully seated in the instrument panel (I/P) trim panel retainer and valance panel.
  3. Disconnect the electrical connector.
  4. The tether clip at the upper portion of the garnish molding MUST be replaced every time the windshield side garnish molding is removed.
scientia non olet · About LEMON Manuals