LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Trax LS, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Repair Instructions >> Rear End Spoiler Replacement

Rear End Spoiler Replacement

Fig 1: Rear End Spoiler
GM2844867Courtesy of GENERAL MOTORS COMPANY
Rear End Spoiler Replacement

Callout Component Name

Preliminary Procedure

  1. Open and support the liftgate.
  2. Remove the liftgate upper center trim finish panel. Refer to Liftgate Upper Center Trim Finish Panel Replacement .
1 Rear End Spoiler Bolt (Qty: 4)
CAUTION:

Refer to Fastener Caution .
2 Rear End Spoiler Nut (Qty: 3)
CAUTION:

Refer to Fastener Caution .
3 Rear End Spoiler

Procedure

  1. Apply masking tape to protect the area around spoiler.
  2. Using a trim type release tool disengage the two rear end spoiler clips.
  3. Remove the grommet from the liftgate outer panel.
  4. Disconnect the electrical harness connector.
  5. Disconnect the rear washer hose.
  6. Remove the rear end spoiler.
  7. Transfer parts as needed.
scientia non olet · About LEMON Manuals