Component Testing
Heated Steering Wheel
- Ignition OFF, disconnect the X1 harness connector at the heated steering wheel.
- Test for 6000-35000 Ω between the signal terminal A and the ground terminal B.
- If not within the specified range
Replace the E15 Steering Wheel Heater.
- If not within the specified range
- Test for 1.5-3.0 Ω between the control circuit terminal C and the ground terminal D.
- If not within the specified range
Replace the E15 Steering Wheel Heater.
- If within the specified range
- If not within the specified range
- All OK.