Component Testing

Seat Adjuster Switch Test

1. Ignition OFF, disconnect the harness connector at the Seat Adjuster Switch - Driver.
2. Test for infinite resistance between the ground terminal D and each signal terminal with the switch in the open position.
   • If less than infinite resistance 

     Replace the Seat Adjuster Switch - Driver.

   • If infinite resistance 
3. Test for less than 2 Ω between the ground terminal D and each signal terminal with the appropriate switch in the closed position.
   • If 2 Ω or greater 

     Replace the Seat Adjuster Switch - Driver.

   • If less than 2 Ω 
4. All OK.