Rear Output Shaft Seal and Bushing Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Rear Output Shaft Seal and Bushing

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Transfer Case Rear Output Shaft Bushing Procedure Install the bushing on the finger section of the J 45380 remover/installer. Install the finger section to the main body of the J 45380 remover/installer. Position the bushing and tool to the rear case half. Press the bushing until the tool bottoms on the rear case half. NOTE: If the bushing was removed, a new bushing must be installed. Ensure the bushing is installed squarely into the bushing bore. Follow the steps for use of the J 45380 remover/installer. Special Tools J-45380 Transfer Case Rear Bushing Remover and Installer
2	Transfer Case Rear Output Shaft Seal NOTE: Align the notch on the seal between the rear output bearing retaining ring access holes, this will position the weep hole down. Special Tools DT-48210 Seal Installer J-8092 Driver Handle

Callout

Component Name

Transfer Case Rear Output Shaft Bushing

Procedure

NOTE:

Special Tools
J-45380 Transfer Case Rear Bushing Remover and Installer

Transfer Case Rear Output Shaft Seal

NOTE:

Align the notch on the seal between the rear output bearing retaining ring access holes, this will position the weep hole down.

Special Tools