LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Tahoe LS, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Valve Lifter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE:

When reusing valve lifters, install the lifters to their original locations.

    Fig 1: Exploded View Of Lifter Guides & Lifters
    GM1402040Courtesy of GENERAL MOTORS COMPANY
  1. Lubricate the valve lifters (209) and engine block valve lifter bores with clean engine oil.
  2. Insert the valve lifters into the lifter guides (210). Align the flat area on the top of the lifter with the flat area in the lifter guide bore. Push the lifter completely into the guide bore.
    3. Fig 2: View Of Lifter Guides & Lifters
    GM1402039Courtesy of GENERAL MOTORS COMPANY
  3. Install the valve lifters and guide (210) to the engine block.
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the valve lifter guide bolts.

    Tighten 

    Tighten the bolt to 12 N.m (106 lb in).

  5. Install the cylinder head and gasket. Refer to Cylinder Head Replacement - Left Side , or Cylinder Head Replacement - Right Side .
scientia non olet · About LEMON Manuals