LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Tahoe LS, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Harness Electrical Connectors & Inlet Hose Clamp
    GM1697098Courtesy of GENERAL MOTORS COMPANY
  1. Remove the intake manifold. Refer to Intake Manifold Replacement .
  2. Disconnect the engine harness electrical connector (1) from the oil pressure sensor.
    3. Fig 2: View Of Oil Pressure Sensor, Washer And Valve Lifter Oil Filter
    GM1402008Courtesy of GENERAL MOTORS COMPANY
  3. Using the J 41712  oil pressure switch socket or equivalent, remove the oil pressure sensor (706) and washer (707).
  4. Remove and discard oil pressure sensor filter (452).
scientia non olet · About LEMON Manuals