Removal Procedure
WARNING: This page is about a different variant/trim than selected.
CAUTION:
When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will result in a damaged oil pickup unit.
- Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
- If the vehicle is equipped with four wheel drive (4WD), remove the front drive axle. Refer to Differential Carrier Assembly Replacement (9.25 Inch Axle) , Differential Carrier Assembly Replacement (8.25 Inch Axle) .
- If the vehicle is equipped with 4WD, remove the front drive axle bracket bolts and bracket.
- Remove the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side .
- Remove the air conditioning (A/C) compressor bracket. Refer to Air Conditioning Compressor Bracket Replacement (HP2) .
- Remove the engine mount to frame bolts (1).
- Place an adjustable (screw type) jack to the tab (1) located on the engine block.
- Working through the wheelhouse opening, remove the engine mount to engine bolts (1).
- Using the adjustable jack, raise the engine slightly until there is enough clearance to remove the engine mount.
- Remove the engine mount.
NOTE:
DO NOT raise and/or support the engine by the crankshaft balancer or oil pan.